EMC 4011-1012-1

EMC 4011-1012-1 Laird A=3,0mm; B=13,0mm; C=3,0mm; D=6,0mm
Enviro-Seal Strips with Pressure-Sensitive Adhesive (PSA) ElectroNit® EMI Gasketing Elastomer+Knitted wire mesh, Material Monel

ElectroNit® EnviroSeal EMI gaskets consist of knitted wire mesh
adhered to a sponge elastomer. Wire mesh knitted over elastomer
is shown separately (pages 16-18). This combination provides both
EMI / RFI shielding as well as environmental seal. Combi gaskets are
available in continuous lengths and different profiles or as frame
gasket made per customer specification. Combi gaskets can be
supplied with an adhesive backing on the elastomer to facilitate
assembly. Special combinations are possible at any time. Gaskets
shown herein only indicate some of the possibilities.
The recommended compression is 20 % of the total thickness.
Combi gaskets can compensate major uneven spots and are
therefore often preferred as lid gasket in enclosures. Despite the low
compression required, the gasket provides a constant shielding
performance and environmental seal and will not be affected
adversely even in case of repeated opening /closing. The combi
gasket can also be equipped with compression stops as additional
protection.